Posted by Michael Soldan on September 12, 2017 at 06:34:33 from (208.96.91.48):
In Reply to: New to me M Farmall posted by Unclemerle on September 12, 2017 at 04:24:12:
That is a neat find, tricycle front end and loader. Re brakes, undo the springs and remove all bolts from the brake pan. Pry all around while trying to move the activating lever in the pan, when you have space enough, squirt penetrating oil into the area of the activating lever. This lever is set into the transmission case and ran on a brass collar. In old M's and H's the brass collar likely wore out and the metal surfaces have rusted together seizing the brake . I got one of an H one time where I had to use a large crow bar to get it out and a lot of pounding, it took the better part of the day. Once off you can clean the bore hole and clean up the end of the activating lever ,install new bushings and grease and you will be good to go. For seized engine, get the spark plugs out and get some penetrate into the cylinders, I'm thinking rain water has got into the exhaust . Jack one rear wheel of the tractor up off the ground,put the tranny in 5th gear and rock the rear wheel back and forth,it may break loose. If it persists you may be removing the head and doing a tear down, but examine everything before you do that. A seized engine stored in a dry place means the engine was tight and and will likely be ok once it is unseized. By your picture there is no muffler or cover over the exhaust so rain has likely got into the cyliners. It is a good looking unit and with some work you will have a nice loader tractor
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.