Posted by kcm.MN on September 14, 2017 at 18:22:15 from (174.219.1.225):
In Reply to: Battery discharging posted by chris english on September 14, 2017 at 17:01:26:
In past years (ie:, long, long ago), the shells used for batteries would cause condensation on the shell (or case) and there apparently was some amount of moisture movement that was capable through the shell. When this would happen, the condensation could make a very slight contact between cells, thereby discharging them over a few weeks time.
Has been quite a while since I had that explained to me, so probably did not do a very good job of explaining it, but hopefully it's enough to answer the question.
Shells nowdays are made of different materials that cannot allow moisture to permeate through. Now, some folks will say, "Hey, if the cases are waterproof, how can moisture get through?" The best way I can answer that question is to point out a fabric called Gore-Tex that is used in many rainsuits and other clothing. This material will not allow for "water" to flow through, but will allow water vapor to pass to the outside. Gore-Tex is nice as the vapor seems to flow in only one direction. But for the battery shells of yesteryear, moisture vapor could pass both ways through the seemingly impervious materials.
Another example (and probably a better one) is concrete. In the old days, concrete was used to built cisterns, and even though they held water, water vapor could still pass through.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.