Posted by Steve@Advance on September 20, 2017 at 13:35:55 from (24.182.105.179):
In Reply to: OT computer HELP posted by Keith Molden on September 20, 2017 at 12:16:11:
Too late now, but the first thing to do is unplug the charger and take the battery out!
But, hopefully the problem is in the keyboard. Go ahead and remove the battery, start opening it up, try to get the keyboard out.
Look under the keyboard, see if anything made it any deeper. If so, keep digging, try to get to the wet areas. As you unplug wire harnesses, take some pictures or make notes so they can be plugged back in correctly. It is usually obvious, but some will plug in either way. Don't want that to happen.
If the coffee was just black, you can dry everything out with a hair dryer or let it sit in the sun for a while. If the coffee was sugared, you can clean the majority off with a wet q tip.
I flushed the keyboard on mine with the sink sprayer, it was severely flooded with half sugar/half coffee thanks to my daughter...
You can spray the boards with contact cleaner, be careful not to melt the plastic or get it on the screen. Let everything dry and give it try. I saved mine and it was really soaked.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
