Each state sets trailer length; overall truck trailer length; width; weight; height; if doubles or triple trailers are allowed. It was a very complicated system because while you were legal in this state you go across the line into another state and now you are over sized and over weight.
So maybe 20 or 30 years ago the federal government stepped in and set standards all states must follow. Some states went to squawking sighting safety concerns because not all state roads were big enough to handle this size truck. So the feds; rather than back down limited the new rules to federally funded national highway system. They allowed you to go 1.5 miles off the system to reach a truck stop; loading/unloading site or trucking terminal.
The feds set the standards at 53 foot single trailers; doubles allowed with trailer length of 28 feet; 80,000 lbs gross weight; 102 inches wide; 13 feet 6 inches tall; and no maximum overall length. When these rules went into effect is when you seen the demise of the cab over truck because of the overall length being done away with.
Non commercial trucks and Rv's still have to follow the state laws as they are not exempt under the federal law. As the years go past we are seeing a lax of the state laws to reflect the federal law. Such as I do not know of any state that still has the 45 foot long 96 inch wide rule. They have all moved to 53 feet long and 102 inches wide except maybe Hawaii. But states still have overall length laws. My state (La.) is 70 feet long. Many states are 65 feet long for non commercial units.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Lifetime of Farm Machinery - by Joe Michaels. I am a mechanical engineer by profession, specializing in powerplant work. I worked as a machinist and engine erector, with time spent overseas. I have always had a love for machinery, and an appreciation for farming and farm machinery. I was born and raised in Brooklyn, New York. Not a place one would associate with farms or farm machinery. I credit my parents for instilling a lot of good values, a respect for learning, a knowledge of various skills and a little knowledge of farming in me, amo
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.