Posted by kcm.MN on October 06, 2017 at 20:23:34 from (174.219.4.103):
In Reply to: Question???? posted by Greg1959 on October 06, 2017 at 14:50:24:
Found it! Here's a video from a guy who sent an endoscope down into a compressor tank, almost twice the age of yours. He also has another video where he cut open the tank from another compressor to see what was inside.
After the video from the endoscope, he took a couple of magnets and pulled lots of rust from inside the tank, stating how the rust flakes were still quite moist even though no water was blowing out. Venting the air from a tank releases pressure and excess (or puddling) moisture, but not the moisture film, which continues to eat away at the inside of the tank.
In your case, you say how the compressor has been outside for 20 years - I hope at least covered. In any case, ANY such tank that is not within an insulated area is going to be more prone to temperature swings, which can cause additional condensation on outside of tank. Add in nighttime dew. Now add in any bug juices or bird poo that might be somewhat corrosive. Add in grass/leaves blown in by wind or the lawn mower, let sit with moisture and it'll rot, not helping the tank any, that's for sure!
So, if you write a post stating your concern against the tank failing, then the best course is to replace the tank. As the compressor needs repair, get a new compressor.
"Most" such tanks will not blow, but rather develop small leaks. If someone continues to use the tank even with it leaking, then eventually it will blow. If someone tries to "fix" the tank (like when welding), then there's a good chance they are creating a ticking time bomb! The 2nd link below is from a security camera that happened to catch one air tank that blew, and it wasn't a pretty sight! That's why I wrote the post as I did.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Lifetime of Farm Machinery - by Joe Michaels. I am a mechanical engineer by profession, specializing in powerplant work. I worked as a machinist and engine erector, with time spent overseas. I have always had a love for machinery, and an appreciation for farming and farm machinery. I was born and raised in Brooklyn, New York. Not a place one would associate with farms or farm machinery. I credit my parents for instilling a lot of good values, a respect for learning, a knowledge of various skills and a little knowledge of farming in me, amo
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.