Posted by Billy NY on October 10, 2017 at 15:27:26 from (74.76.4.60):
In Reply to: small seed planting posted by Case Nutty 1660 on October 10, 2017 at 05:52:07:
The geographical area in which the participants here spans North America, as well as much of the globe. Means and methods are always going to vary. Around here, every field will vary. I think that is the simplest way to put it.
I've done lots of small grains, grasses in years past, and worked with a farmer that knew how to get some of the best stands of hay, alfalfa and grain crops in this area. He developed his methods over time, but started when he was young. Even his father questioned what he did, as he told me when he first invested in a JD 420 and JD tow behind combine for his and custom work He proved people wrong by doing, paid off his debts and knew how to work this area as best can be done. Take that somewhere else, it may not work well or at all. His hay fields were planted with grain crops and the stands are the best I have seen. Not many hay fields are maintained or nurtured like his were, to this day. I learned a lot from him and think of him every time I walk into our fields.
The way I see it, you have to start off with what is typical for your area, then experiment with means and methods to see what you can improve, or what will not do so well, in both scenarios, knowledge is gained and that is how my long time friend did things. He also changed with the times where it made sense,but some of his methods were timeless and re-inventing the wheel just makes no sense.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - 12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.