Posted by Goose on October 22, 2017 at 19:27:21 from (174.217.23.113):
A few days ago, my wife used this 60 gallon sprayer I built for real for the first time.
The area she maintains as our house yard is a bit over two acres. According to the chart that came with the sprayer nozzles, at a ground speed of 3 ½ mph the sprayer would put down 25 gallons per acre. I verified the gear and throttle setting on the garden tractor with a portable GPS to produce a ground speed of 3 ½ mph, then did a test run with clear water.
When my wife sprayed for real, one 60 gallon load came out exactly even. It took her less than an hour to do what previously would have taken several hours and several reloads with her old 25 gallon sprayer.
It was not without bugs, however. The 3.8 gpm 12 volt pump draws a few more amps than the charging system on the tractor puts out. The pump ran fine through the whole process, but when my wife was done and parked it, the battery was drawn down to where the tractor wouldn’t restart. A temporary fix was I mounted a spare garden tractor battery on the sprayer and wired it in parallel with the battery on the tractor. The battery will still draw down, but it will take longer. I’d like to use a bit bigger tractor without a deck to pull it. Then I could run a car sized alternator off of the deck drive pulley.
Also, it’s become obvious the hinges in the booms aren’t quite hefty enough. I can easily cut these out and replace them with heavier ones. And, I’d like to put a manifold on it so you could shut the nozzles off on either side for spraying the driveway ditches, etc.
It’s been a learning experience, particularly considering the whole thing started when I bought the bare tank for $10 on an auction with no idea of what I’d do with it.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: 1964 JD 2010 Dsl - Part 2 - by Jim Nielsen. Despite having to disassemble the majority of my John Deere 2010's diesel engine, I was still hopeful I could leave the engine-complete with crankshaft and camshaft-in the tractor. This would make the whole engine rebuild job much easier-and much less expensive! I soon found however, that the #4 conrod bearing had disintegrated, taking with it chunks of the crankshaft journal. As a resul
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
