An aspect that's often overlooked by DIYers is site preparation. If your building site isn't properly graded, there's nothing you can do AFTER the building is up. Make sure you have good drainage in all four directions, and that you have a gentle approach to the main door. Any fill you bring in needs to be well-packed before you pour concrete.
My building is 30x40x10, and yes it's full. But it's a very practical size and reasonably easy to heat. The size was dictated by my building site and budget; I don't regret not building it bigger, although I might well end up putting up another building in the future. The bigger the building, the harder it will be to erect it yourself. You and three or four buddies can easily hang 30 foot trusses; 40 or 50 foot trusses are tough.
I have no regrets going post frame versus stick. Other than setting the posts and hanging the trusses, I did almost all the work myself.
I put in a large floor drain, and haven't used it. I'd rather have a flat floor, but that might change if I heat the building and start parking wet vehicles in it.
My 30 foot trusses have a small attic space in them. I put a floor in this area and installed an attic stair; I store stuff up there I don't expect to need anytime soon.
My floor, reinforced with wire mesh, is 4 inches thick around the building perimeter and 6 inches thick in the middle and at the entrance. Thicker concrete is less prone to cracking and requires fewer control joints. I have NO cracks in my floor. I insulated the floor and installed PEX tubing for heat; maybe if I ever finish insulating it I'll get the heat working.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Usin Your Implements: Plow and Disc - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.