I sold a John Deere 216 platform two weeks ago. The buyer was coming back through with a goose neck flatbed the next week after delivering a piece of machinery to a consignment sale and really wanted to haul it home on that. I told him I couldn't raise it that high with the combine. He said he moved them around all the time with a tractor and loader. So, I said we could try it and if it didn't work he would come back with a head mover. It lifted fairly easily with a John Deere 2840. Was light on the rear and didn't want to back up without spinning. Put a heavy blade on the 3 pt. and it got good traction. Like others have said if your bucket has a cutting edge that extends outward a little that helps get a bite under either the round tube or the upright supports on the left and right. Pallet forks do work great, but they need to be tilted downward a little so they lift under the rear main frame and not the sheet metal underneath. Guy that bought mine said once they bent the sheet metal up into the auger. Probably the universal way without pallet forks would be the use of 4 log chains. One on each side of the bucket hooked tight to something heavy underneath and the other two hooked to the back of the bucket then attached to the top frame on the head, sort of like the top link on a 3 point. If your tractor isn't large enough maybe a neighbor with a larger tractor could help. I assume you have a hydraulic bucket so you can "curl" the head down flat on the trailer. I wouldn't do it with a trip bucket. Good luck.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
