Posted by Bob on November 12, 2017 at 11:45:40 from (64.255.159.192):
In Reply to: Re: Governor adjustment posted by Txpoweranger on November 12, 2017 at 09:39:27:
When reinstalling the throttle plate it needs to be carefully centered in the bore before the 2 screws are tightened completely.
If it is not centered properly it can mess up the function of the idle and transfer circuits, making for surging. (One side of the plate meets the bore in the area where there are drillings from those circuits into the throttle bore.)
The throttle plate typically has oversized holes, allowing for a little adjustment.
Back the idle speed screw off enough so the throttle plate can fully close and note how it fits in the bore, should be snug up against the bore all the way around.
If not, slightly loosen the screws and tweak it around 'til it is, then carefully tighten the screws while being careful not to jam the plate in the bore, then screw the idle speed screw back in at least enough to keep the plate from tightly closing, and reset idle speed after startup.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: 1964 JD 2010 Dsl - Part 2 - by Jim Nielsen. Despite having to disassemble the majority of my John Deere 2010's diesel engine, I was still hopeful I could leave the engine-complete with crankshaft and camshaft-in the tractor. This would make the whole engine rebuild job much easier-and much less expensive! I soon found however, that the #4 conrod bearing had disintegrated, taking with it chunks of the crankshaft journal. As a resul
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
