I figure I might quit wood soon. Maybe if I lived in NJ I'd go longer with the milder winters. . I cut my own wood for 40 years in central and northern New York. Often used a 12-14 full-cords per winter. Had all my own hardwood forest. That said, the wood was not free. Cost of my dozer or tractor, truck, chainsaws, fuel, woodsplitters, cleaning chimneys, time spent cutting, blocking, stacking, splitting, etc. Not cheap at all, in the end.
Now living in northern Michigan by Lake Huron and Lake Superior. Same basic cold dismal winters as central New York. Cold is just more steady. But - I have 100 acres of forest and NO hardwood. Just white pine, cedar. balsam fir, and poplar.
So now I buy truck-loads of hardwood tops. I just got done cutting and splitting two year's worth of wood.
I just sat down and figured the cost. My firewood, assuming my time is worth nothing - cost me 5 cents per BTU of heat. Wood pellets cost me 3 cents per BTU. Plus with the pellets - no cleaning chimneys, no stacking, no splitting, and NO starting fires. Kind of a no-brainer.
I bought a pellet stove for my large shop on sale at Tractor Supply. I used to hate even the thought of pellet stoves. Now? I love this thing. I have around 1 year's worth of wood left and then, I think, I am done.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
