Posted by fixerupper on November 23, 2017 at 15:48:25 from (100.42.94.143):
The Dodge dealer tells me the ECM is bad in my 24 V Cummins and I don't doubt him from the way it acted. The dealer quoted a new ECM at $2500. I have replaced ECM's in N14 Cummins truck engines that ran that much money too so I suppose the $2500 figure is close to being right. A used one is hard to find and might not be able to be flashed and reprogrammed right.
On the net I see ECM's for this pickup advertised for $746 ready to go, plug and play. I give them my VIN number and they send me the ECM. That's quite a difference in price and I tend to be a little leery of the ECM's advertised on the net. Do any of you guys have any experience with internet bought cheap ECM's? Are they good or not so good? This ECM in the pickup was making the engine run wild when I started it hot, not good! It's like putting the pedal to the floor, starting the engine and holding it there. I don't want this happening again, a $2500 ECM is cheaper than what could happen when it runs wild.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Lifetime of Farm Machinery - by Joe Michaels. I am a mechanical engineer by profession, specializing in powerplant work. I worked as a machinist and engine erector, with time spent overseas. I have always had a love for machinery, and an appreciation for farming and farm machinery. I was born and raised in Brooklyn, New York. Not a place one would associate with farms or farm machinery. I credit my parents for instilling a lot of good values, a respect for learning, a knowledge of various skills and a little knowledge of farming in me, amo
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.