Posted by robert major on December 05, 2017 at 12:27:49 from (142.160.15.219):
In Reply to: Re: Raising Pigs posted by Texasmark1 on December 05, 2017 at 05:45:04:
Why would you want to try keep the water that clean, I got 6 straw based barns 200 hogs in each with 6 hole waterers with lids on bolted to the floor in the feed area, they should lift the lid to drink from them. When I scrape the concrete they blow bubbles in the resulting pig muck that goes over the edge. They then either go to the feed trough or the waterer after this contaminating one or both.
If the waterer gets full of slop/ corn meal I clean it out then, by hand or between batches it's drained and hosed out. I could make a career out of trying to keep water clean every day all day, but not make any more money. just for fun mine rip the lids off and hide them in the bedding so you have to find whats missing, or bend them so they don't close. Or if they find small stones they drop them in the waterer and shove them under the float housing jamming it up, so they got no water.
Anybody that feeds any number of hogs, that has no sense of humor won't last long at it. The hog will win one or two rounds even if it's in the last 5 minutes you own it going on the truck. Regards Robert
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.