Posted by John Deere D on December 05, 2017 at 23:05:45 from (204.244.59.66):
In Reply to: gas line hit posted by 730virgil on December 05, 2017 at 09:42:56:
I retired in my 40 th year from a Company whom owns, operates, and maintains a major Natural Gas Pipeline. We had 1000 miles of 30" .375 wall...1000 miles of 36" and miles of 48" Looping. Every 60 miles there was from 30,000 hp. > 50,000 hp. Compressor Stations to maintain line pressure, and keep the product moving. Typically the Inlet PSI at a Compressor Station was 575>675 PSI and the outlet was set a Max operating PSI of 936. We moved 2 Billon cubic feet / 24 hrs.
Gas Line hit......I feel deep pain and sorrow for those any were near such an incident. I've witnessed such an event.I shall never forget it.
Bob...Retired Power Engineer / Gas Turbine specialty:
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
