Posted by gbs on December 10, 2017 at 13:17:10 from (76.3.123.59):
I searched several different locations and posted messages about a problem with a JD 310sj tc backhoe so far no luck, so I'll try here neighbor has a 310sj tc backhoe that the hoe boom won't raise unless you hold another function open with it at it full range of travel, also the bucket doesn't have much strength when curling in, solenoids are working on each cylinder valve. this machine has electric arm rest mounted controls and form what I can find the hyd. system is open center, this set-up uses only 2 lines from the tractor to the hoe each of which are teed to the boom cyl. control valve assy., then run to the dipper cyl. control valve assy. and are teed to it, then on the bucket cyl. valve assy. there one is connect to each side of the valve, each valve has 4 solenoids mounted to it and a module mounted on top with a multi pin wire connector, can anyone explain how these valves work in unison to control fluid flow being this is suppose to be an open center system and the valves are connect together as if it were a close center system I have worked on similar open center set-ups but not like this one with all the electronics, the problem is most likely something simple but not having any info. on this set-up I at a cross roads, I would like to be able to help him out with this problem been he asked me to, he said the last mechanic even as knowledgeable as he is tried and walked away, he don't mind paying for repairs but he doesn't like paying a 100 plus dollars and hour for someone to be trained on his time plus the unnecessary parts changing, thanks in advance for any info in advance
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.