Posted by Bob on December 16, 2017 at 12:05:09 from (64.255.159.199):
In Reply to: pto rpm posted by 88-1175 on December 15, 2017 at 21:38:07:
[quote="CVPost-David G"](quoted from post at 09:24:46 12/16/17) I think most governors would run wide open around the 540 RPM./quote]
What one would THINK doesn't always hold true. High idle on many tractors was quite a bit above rated PTO speed.
Using a simple Ford 8N as an example, 1500 engine RPM's gave approximately 545 RPM's at the PTO, rated engine speed was 2000 RPM's, giving a PTO speed of 727 RPM's at full throttle, and there many other tractors set up in a similar fashion.
Looks like 1500 RPM's was the maximum torque speed of the little 8N's.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
