Posted by DR. EVIL on December 17, 2017 at 04:35:45 from (174.198.5.47):
In Reply to: New snow plow posted by Don-Wi on December 16, 2017 at 21:02:49:
I've been pushing snow with a 16 inch tall by 80 inch wide blade pinned straight onto the loader arms of the loader on my Super H for 22 years. Most of the places I push snow are short so snow dribbling off the side is no problem. I raise the front wheels of the tractor off the ground when cleaning my concrete driveway. Winter of '07/'08 when we got over 101 inches of snow I had snow piled up 8-10 FEET tall. I've never felt the need to be able to angle the blade on my loader, would add way too much length to the loader&tractor and make it difficult to get in some places. I back drag snow from several places. A blade raised with a chain couldn't do that.
Had a snow blower on a garden tractor but got tired of wearing so much snow, plus it would have been really slow going on some of the snows I've pushed. Made the mistake one snow of driving into the shop with the tractor. Next snow had a 3+ft tall drift in front of the door, took several tries to get thru that drift, had snow piled a foot tall on top of the pto shield when I finally got out.
Had a day in about 1998 where we had severe blowing snow early one morning, decided to stay home from work with the 145 mile round trip commute. Spent the day pulling people out of the snow drift in front of our house, Son & I pulled a dozen cars out, about 10 AM I gave up trying to keep the drift cleared out. It must have been 4-5 ft tall. Packed in so solid our St. Bernard dog easily walked on top of the snow.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
