Posted by JD Seller on December 19, 2017 at 16:59:05 from (208.126.196.24):
In Reply to: horse fence posted by jim buford on December 19, 2017 at 16:26:34:
I have a PTO driven wire roller. You just unclip the fence and then roll the entire run up. The one on the right is the kind I have. Most of the newer ones are hydraulically driven. They are better but cost more.
A friend of mine made on that he drove with one wheel of his garden tractor. It made smaller rolls as his reel had to be smaller than the OD of his retire on the garden tractor. He basically took a flat plate an cut a circle a little smaller than his rear tires. He drilled holes in the plate that lined up with the four holes in the rim that you would install wheel weights on. Then he cut pipe spacer so he could run long bolt through the rim and anchor the plate to the rim/tire. The he made four "L" shaped bolts that bolted to the plate about four inches in form the outside. So with the four bolts turned so they foot was out you had the spool holder. He then would park the mower in line with the wire he wanted to roll up. He would jack the one tire with the roller on it up high enough to clear the ground. Then just hook the wire to one of the four "L" shaped bolts. You wanted to hook close to the plate so it would not bend the bolts when you started rolling the wire. Then just run the mower tire to roll up the wire. When the wire starts filling the spool it helps support the bolts. When you had it full you just loosened the bolts and turned them in so the spool of wire would come off. If you do not have real long runs of wire this would work.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
