I bought a Kohler 20 KW whole house back up gen set in 2014. I did my research and shopped just about everyone before doing so.
I had both Kohler and Generac dealers come to my site and make proposals. I was very impressed with the Generac dealer because he was well prepared, knew his stuff and did not try to sell me something other than what I wanted. In short, I trusted him.
Kohler dealer, not so much because he was less knowledgeable and tried to sell me a smaller model that I did not want (probably had it in stock). FWIW, my relationship with the Kohler dealer has become VERY much worse thereafter for reasons that I will not relate here, but he is no longer allowed on my property.
In any event, I bought my Kohler genset online and installed it myself. There have been hiccups due to my inability to get needed information from dealer or Kohler but, after considerable frustration, time, and assistance from the Kohler distributor (not dealer), who has been excellent my issues have been mostly resolved.
FWIW, even though I liked and trusted the Generac dealer and was suspicious of the Kohler dealer (subsequently proven justified), I bought the Kohler unit mostly because the engine has hydraulic valve lifters whereas the Generac engine does not. Not wanting to adjust the rocker arms every two years (or pay the Generac dealer to do so), required to maintain the Generac warranty, I bought the Kohler unit.
Hiccups aside, so far so good.
Cannot say who builds Generac engines but suspect that they are Chinese Kohler clones.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.