I couldn't imagine having three or four buildings. But as you said, it didn't happen overnight. I started wrenching in my grandpas front yard around 12 years old or so... From there it migrated into his dirt-floor garage which was double deep, and two car wide. If I had to put a number on it, it would probably be 24X36 or so... Relatives sold the grandparents place when I was about 16, and until I had bought this townhouse with a single car garage it was back to the elements... Moved into the townhouse in 2007, and have been wrenching there ever since. Started accumulating more tractors, and have been bouncing between outside at friends places and inside at the townhouse.. Still not heated, but it stays fairly warm due to being 1/2 underground and sharing common walls. Either way, I will be excited to move to a place that has a little more room... As my collection continues to grow, though, and still being close to the city.. I may have to stop collecting quantity and start wrenching more... Uff, that will be a hard one to stomach!
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
