Posted by carvel minne farmer on January 09, 2018 at 15:22:39 from (207.228.78.200):
In Reply to: thinking shop. posted by Brent Zappe on January 09, 2018 at 08:07:52:
brent my metal shop is a u.f.a. building (united farmers of alberta) this building is on sale every spring, it is a machinery storage shed, ploe construction 6" x6" posts with 2 x 4 strapping horizontal inside and out. comes with sliding doors, I got them to swap out the sliding doors for a 12 x 12 overhead door. the cost of the package in 2004 was $14,500.00 and another $8,000. for the crew to come out and build it to the lockup stage. I then spent the next 4 years finishing the inside nights and weekends, installing water and sewer system, wiring, cement floor, insulation, 9"in the walls and 28" in the ceiling, plumbing, hotwater system, pipeing in air all around the shop, and finished the inside walls with the same metal sheets as the outside. I estimate I now have close to $100,000. total into it with me doing the work.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
