If you wrench for a living you will ware tools out now do you want to buy them over again that's were Snap-on and MAC shine if you don't misplace it you buy it one time... 99.9% of the time no questions asked.
Noting will hold up used daily as good as Snap-on or Mac, SK is not in the same ballpark. A few SK tools will run with them but not all of them...
I own quite a few SK tools it was a bad dissension on my part they are worn out and hard to get repaired/replaced... The price difference and warranty was inviting at the time... They get replaced with Snap-on what I should have brought the first time.
As for breaking a 12 pt socket in a tight place that's the way it is it is probably the only tool that will get in there and get the fastener out. I have broke more chrome 5/16 12 point sockets than the law allows most of the time its the only tool that will get on the fastener. I try my best to use impacts when all possible sometimes its not possible...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
