Posted by rohdog50 on January 13, 2018 at 18:11:07 from (50.51.124.160):
In Reply to: Re: Hey Old posted by JD Seller on January 13, 2018 at 16:51:01:
JD Seller,
This tractor is 52 years old,i really don't use it that much....maybe 40 hrs a year the 87 octane fuel here(northern ohio)goes bad in 2-3 months,which is another reason I run 93 octane fuel and seafoam as a fuel stabilizer.I have other newer gas equipment that runs fine on 87 (2 cub cadet riding mowers,pressure washers,generators,airless paint sprayers,1-ton truck....etc) But again they may sit for months without use....and for that reason and my piece of mind,all my gas equipment gets 93 octane with seafoam mixed in. I have done this for well over 10 years now and have had 0 problems with fuel going bad and carburetors being pluged up.I just sold our old 1974 ford F700 farm truck last year,it had the 361 HD motor....it ran like crap too on 87 fuel so we had to run 93 octane in that one too.....like I said before,on these older gas motors,they were made to run on 93. Our fuel here isn't the greatest.......lol
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
