Posted by c.amick on February 05, 2018 at 17:45:09 from (71.53.193.130):
In Reply to: Any apple gurus here? posted by Dave H (MI) on February 04, 2018 at 13:39:53:
You can use most other common apple tree types for root stock, if you just want a standard size tree. I dig up volunteer trees that I find which came up from seed and use them. (You could put graphs on the tree you planted.) You have to do it after freezing weather and before the buds start to open. I like using cuttings about the diameter of a pencil or a little larger. What ever you are putting it on has to be the same diameter so the bark edges will line up. I cut mine at a pretty steep angle so there is a lot of contact area between the two pieces. The cuts need to match up well, flat against each other. I hold them together and wrap them very tightly with electrical tape. Wrap it several times so that you have a nice stiff joint. Late in the second year of growth, split the electrical tape vertically in a couple places to allow for expansion. DO NOT ATTEMPT TO PEEL OFF THE ELECTRICAL TAPE. THE BARK WILL COME OFF WITH IT. The tape will eventually fall off on it's own.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.