Posted by Goose on February 12, 2018 at 15:46:13 from (174.217.18.154):
Does anyone know offhand where the Ambient Air Temperature Sensor is located on a 2007 Chrysler Town & Country van? I haven't started looking yet, but I assume it's somewhere in front of the radiator where "clean" air will hit it as it provides the signal for the outside thermometer, among other functions.
Here's the scene. A week or two ago the heater and outside thermometer started acting strange. I put my scanner on it and had a code P0073 for the ambient air temp sensor. I didn't have time to mess with it so my wife took the van to our local Chrysler dealer. They replaced the sensor for $55 and everything worked OK for a couple of days, then started acting up again. My wife went back to the Chrysler dealer today and they told her it was a wiring problem that could cost a couple hundred dollars to find.
Knowing that outfit, they may well have installed a new sensor that failed after a couple days, and then instead of just replacing the sensor under warranty, they'll try to recoup their labor by claiming it was a wiring problem.
Anyhoo, thanks in advance if anyone knows offhand where the sensor is located.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
