Might take me a little longer to make hay than some for sure but I'd bet I make some of the lowest cost hay around.My line up for hay equipment. Cut hay with a 31 HP Yanmar I paid $2000 for 15 years ago and mow with $500 NH 456 mower uses less than 1/2 gallon hr fuel Rake with a NH 258 rake I bought like new for $1800 20 years ago pulled by a David Brown 780 cost $1200 10+years ago.uses about 1/2 gallon/hr fuel Bale with a NH 851 round baler paid $500 for it at auction 4 years ago pulled it last year with an Allis Chalmers 185 cost me $1000 2 years ago burns maybe 2 gal/hr Also have several back up mowing,raking and baling rigs ready to go in case of a break down. Generally bale 300-400 bales a year.So I'd say my costs run less than $10 bale easily. Also make a few squares every year with an Oliver 62-T baler that I'm still working on the last of the 4 balls of new twine it had in it when I bought the baler at an auction for $200 And the bonus is I pay nothing for the ground I cut hay on because the landowners I cut for get a huge real estate tax break if its in farm use.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
