Posted by coshoo on February 20, 2018 at 09:51:02 from (65.101.153.130):
In Reply to: Hauling Tractor posted by Randy K. Crump on February 20, 2018 at 07:06:24:
Someone below mentioned removing jack and driving it on from the front- I've done that a couple times, and it worked fine- running the tractor up so the back tires of the tractor just touched the front of the trailer fenders made the weight distribution just about perfect, and the trailer followed along just fine. To do it, you'll need to block up the front corners (and the center, with a narrow front tractor), and use planks to get it on the trailer.
That being said, most car trailers have no more than 3,500# axles, giving you max of about 5,000# payload (trailer will weigh about 2,000#). So you'll be overloaded with the 70. Probably would work OK if you have good trailer brakes, and you take it easy on the speed. Check to see that you have 3,500# axles- if it is a light duty car trailer with lesser axles, don't even think about it.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Lifetime of Farm Machinery - by Joe Michaels. I am a mechanical engineer by profession, specializing in powerplant work. I worked as a machinist and engine erector, with time spent overseas. I have always had a love for machinery, and an appreciation for farming and farm machinery. I was born and raised in Brooklyn, New York. Not a place one would associate with farms or farm machinery. I credit my parents for instilling a lot of good values, a respect for learning, a knowledge of various skills and a little knowledge of farming in me, amo
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.