Posted by olgentdc on February 23, 2018 at 08:51:05 from (184.16.114.29):
In Reply to: Today 1945 posted by Ultradog MN on February 23, 2018 at 08:25:15:
SaLUTE , AMEN ,.. Semper fi,.,.May They all Rest in Peace.my dad thankfully missed that bloodfest sitting in the hospital in honolulu /////yesterday ,We laid to rest a Farmer, who at age 18, landed on Normandy beach ,went on across Belgium , and survived the Battle of the Bulge, damnearfrozeto death and got shot in the leg and got out of that durn place . i recall hi m saying that with a chukle , ,The rains parted long enough for the Hearse to stop at his Farm ,We transferred his amish casket to a farm wagon and his Favorite JD 620 with loader , and bale spear , fresh and dirty from feeding the cows just a hour before ,That Ol DEAR JOHN , stated a proud preach as it run in hi gear past all the respectful neighbors as we went to the cemetary the last 5 miles ,.. it was a mighty GOD Bless .Thank You , You OLD Soldiers ,, You Built a Great Nation for us ,Please know i am doing my part to Keep it up,.JUST AS YOU TAUGHT US
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
