Posted by pinball on February 23, 2018 at 19:56:37 from (64.49.150.124):
In Reply to: Re: O T building shop posted by doorman on February 23, 2018 at 16:50:46:
I know the money is always a factor but if you can I would go at least 60 feet long. you will wished you had of later . believe me. I built a pole barn 10x30x60 back in 97. Had them put insulation wrap on it. most part 10 foot is okay. Had 5 inches concrete floor poured. I HAD some people from Oklahoma put it up. They did a great job. 3 guys living in a tent . drilling holes with an motorized post hole digger. used chain say to make trusses. put trusses 4 feet instead of five incase I wanted to put a ceiling in it. I put a garage door in it later. the slider didn't keep all the mudobber out and the garage door solved that. I would recommend that if you install a garage door you fix it so the garage door when closed is actually 1/4 inch below your floor due to those rubber seals always seems to leak in windy rainey weather. due your home work. once you decide for sure what you want as to size of it go to home depot or other places like that and ask them for a bid on the lumber. wont cost you anything and by getting 2/3 estimates you will have a good idea what it will costs. I am in Missouri and wanted to go locally but for 3000 dollars less I decided to go out of state. get the costs of lumber, go on the internet and type in building barns and see what you can fine. get references. I did. Good luck on what ever you do.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
