Posted by JD Seller on March 04, 2018 at 12:46:02 from (208.126.189.95):
Randy's post below reminded me of fighting to move the spacing on the front axles of some tractors. The worst one I ever fought and got to move was JD 4320. It was narrowed up to 30 inch rows. I had it for sale. A fellow came and bought it but wanted the tires set out wider. We broke both rear wedges. Then when we got to the front axle, even with all the clamp bolts removed we could not get it to move. We had two port-a-powers pushing out and heating it red hot, it would not move.
Luckily I but hold downs in the shop floor when I poured it. Just by luck they lined up with the side walk door. S we chained the tractor to the floor so it would not slide. I stuck the boom of my 510 backhoe in the walk door laid out pretty well flat. I chained the outer part of the axle to the backhoe boom. With the out riggers down I pulled the extend-a-hoe boom in. That lifted the front of the back hoe off the ground. Then we heated the axle tube red hot and it finally popped. Had to do both sides that way.
I have since used the back hoe several times to "pull" things to get them to move. Works great for wagon coupling poles. You can pull and shake the heck out of them. LOL
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
