Posted by Adirondack case guy on March 10, 2018 at 16:55:49 from (69.207.198.19):
In Reply to: plowing with a ford posted by Ray Tractor on March 10, 2018 at 16:37:25:
Position control is exactly what it says. The arms drop to a certain point as you move the quadrant lever forward. If the plow has good shears it will drop to where you set the lever. Draft control senses off the top link, and uses the weight of the plow and soil draft to improve traction. The harder the plow pulls the more pressure is applied to spring on your top link and when the spring compresses, the linkage from it starts to raise the plow momentarily. If your draft lever is set correctly. Once traction is gained and wheels stop spinning it will allow the plow to settle back into the desired depth, if as said the plow has good shears so it has "suck". Setting draft control is a balancing act, and top link sensing is rather difficult to control, unless you understand all the dynamics involved. Loren
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
