Posted by SDE on March 22, 2018 at 03:52:05 from (68.190.137.79):
Thank you, I will give Dad's address, can you have it done by June?
The shingles are in really bad shape and need to be replaced, but if you put a string on the West peak and run it diagonally down to the lower East end you will see that there is at least a two inch depression or dip in part of the roof. Maybe even more than that. If you look from the eves to the peak it is very noticeable. My brothers and I feel that to fix this, we will need to remove the entire roof and rebuild it from the upper plate. The 2 by 6 trusses are on 4ft centers, with a 2 by 4 between them, going from the peak to the upper plate. This is what most likely has caused this problem.
Do you think that a complete rebuild is the easier than attempting to straighten it? Unless the weather becomes a factor, I have the time to do it this Spring or summer. TY SDE
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.