This front is really strange. I took the one Grand Daughter to work in Cascade. It was snowing HARD when I left. Between my house and Cascade the snow quit. I just live 2 miles west, by the time I drove back home it had totally quit snowing.
So since I was already out I cleaned the drive. Only took starting three tractors. LOL The one JD 4450 had the blower in it. So I was just going to blow the drive out. No go, just plugged with slush. Had the rear blade on the JD 5210. No go, the snow just balled up in front of it. Started the one JD 4020 I have here and used the loader on it to push the snow off the lane. Only made about 3-4 "new" divots in the yard/lane. LOL
My brother-in-law, that lives in Ohio, went to Reno to pickup an antique car last week. He ended up coming back through Iowa today. He is driving back I-74. IF you look on a weather map this storm is just about perfectly aligned with I-74 from the Quad Cities to Cinn. He is going to be driving on wet and snowy roads all the way home. I told him to stop and spend the night but he has to be back to work Monday.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
