Like I said, I had a 1010 loader with backhoe. On the back of the seat was a push pull splitter valve. The main hydraulic line ran to that valve first, and in normal operation of the loader the valve directed all the flow to the loader valve bank. After backing up to the backhoe and quick couples were hooked up, you pulled up on the splitter valve and the flow went to the backhoe. You did not need to shut it off. Then you could lift the hoe with the outriggers and back into the hangers, and boom it back to put the top pins in. Two minutes tops to hook up the hoe. I never had a 1" quick coupler come appart. I always kept the quick couplers connected on both the crawler and the hoe when not using the hoe, it kept them clean.
I had a log splitter that I could quick couple up to the 1010 and run off the crawler and ran the log splitter with it's own valve like normal just used the 1010 hydraulic at an idle to split wood.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
