Posted by fixerupper on April 15, 2018 at 16:28:49 from (100.42.94.143):
I'm sitting here resting a bit so I thought I would show you the progress on the 1925 T coupe. This is what the roof wood looked like after I removed the canvas top and bows.
The top of the driver's side door post didn't look so good so I cut off the top 8" and made new top wood, doweling it into place.
After hours of removing old rotted wood and fitting new wood from a kit the owner bought this is where it sits now. The doors now close perfect where before they hit the door frame when they were shut because of the rotted roof structure. I'm VERY happy about the way they fit. The wood is partly screwed on and partly clamped together ready to be screwed together.
To back up a ways, all of the bottom wood was rotted, all the way from the back of the trunk to the front of the floor board. I removed it all and made new wood. It was a real guessing game as to how long some of the pieces were supposed to be because sections had fallen out.
This is not a very good picture but the shiny black wood outside of the frame and against the body panels is new wood I made.
These old cars with wooden body frames use plenty of wood screws. So far I have sourced #14X 1", 1 1/4", 1 1/2", #12X 1", 1 1/2", 2 1/2", 3", and 31/2" wood screws. There are a bunch of smaller #6X1/2" and 3/4" screws I'm trying to save and reuse because of the rounded top on the heads.
Anyway, there is a long ways to go yet, he has a new trunk floor ordered if it ever shows up and the interior kit has to be installed but at least now the body is solid again. With the wood gone it was just floppy tin ready to collapse. I have a very helpful and talented neighbor helping me with the assembly as it is a real puzzle without a blueprint and dimensions to go by. The body has sagged over the last 93 years and it's reluctant to be brought back up to where it should be. Anyway, we've been making progress.
Oh, I should note, the owner is 80 years young and this is the first car he owned. He bought it in 1951 when he was 14 years old. He drove it to college and dated his wife in it, among a few others. It holds lots of memories. How many of us have the first car we owned and can still drive it? Not me.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
