Posted by FinnMD on April 20, 2018 at 16:26:54 from (173.153.93.209):
In Reply to: OT: Pole Barn In Stages? posted by Ken Christopherson on April 20, 2018 at 09:26:39:
You can do it in stages. I built my pole barn like that many years ago. Did research on proper rafter size, spacing, etc from websites and books. I built a 32 x 34 barn all by myself, the only help I had was dad helped with setting the 6x6 posts. Hardest part for me was the layout of the site to make sure posts are all in proper position, using the 3,4,5 principle, and the old fashioned water level (clear tubing with water in it to establish relative elevations from post-to-post). Obviously I am not a builder or contractor, just figured it out and made my barn plan on graph paper and pencil with a big eraser. Tractor augered holes for posts, set concrete pad on bottom, when it dries put in post and concrete it again. I used siding of green (wet) oak from sawmill true 1" x 12". When green easy to nail and cut, when dry forget about it. Picture from about 15 years ago, and picture today. Good luck.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
