Posted by Determined on April 22, 2018 at 09:03:59 from (216.130.212.201):
In Reply to: Half done repairs posted by jacksun65 on April 21, 2018 at 19:24:04:
In the end it is up to you on how to repair it.
If you are experienced working with a torch and solder and start with the repair area cleaned up perfectly you will end up with a permanent repair.
If soldering is not one of your strong skills then JB weld can be used for a permanent repair.
-Remove radiator and find a place to lay it flat.
-Clean and dry the area to be repaired.
-On the undamaged side use some play dough or something similar to seal off the area where you are going to do the repair.
-On the damaged side some play dough and masking tape will be needed to surround the repair area.
-Unless it has been banged up real bad the repair area will not be much bigger than a silver dollar.
-Mix up your JB weld (not JB quick), you will need enough to do the repair in one shot so might as well mix the whole tube up.
Once blended thin the mixture with Methyl Hydrate until it is a pourable consistency.
Some say it can be thinned with Isopropanol alcohol but I have not personally tried it.
-Pour the thinned out mixture into the repair area so it fills it completely, front to back.
-Work a thin piece of wire in and out of the mix to help remove any air bubbles.
-Let sit overnight to dry/cure, next day remove tape, paper, play dough and you will have a repair that will outlast the tractor.
-I have used this method many times on brass, copper and aluminum with excellent success.
The aluminum rad in my big block 1-ton trailer hauler was repaired this way 8 years ago and it is still holding up on a vehicle that gets worked hard and hot on a regular basis.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.