Posted by wfw on April 25, 2018 at 05:39:22 from (107.12.3.80):
In Reply to: Need a new tiller.. posted by SodBuster87 on April 24, 2018 at 14:51:30:
I was given a troybilt horse that was built in 1973. engine was bad. replaced engine and a seal and it works good. the only problem I know of with it right now is the tine shaft has a groove worn in it so the seal I replaced will leak again. at that time I will replace the shaft and both seals. I put a harbor freight engine on it, could not afford a briggs right now but will get one later. I have a honda 5 hp but it is just not enough hp for the tiller. I have a 6.5 on it right now. I also have a troybilt superbronco (by mtd) that I have used for several years, it isn't big enough for my garden at the time(I moved and right now have no garden) so it was overworked but it does good also. you can still get parts for the old made by gardenway troybilt tillers and they were well built.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
