The big question is, how much torque does a PHD require?
You might be able to go to the mfg, find out what the digger is capable of handling, get a ballpark figure from that.
With that information it's all math. Not easy, but start with what you have (the Case pump), determine what the GPM @ x RPM is, and the pressure rating. Next match a motor to it that will give the desired RPM (flow rate) and torque (pressure rating). The 2 go hand in hand, smaller displacement=higher RPM=lower torque, higher displacement=lower RPM=higher torque. Don't forget you will need a reservoir sized to handle the heat dissipation, a directional valve, pressure relief valve, filter, suction strainer, hoses...
As you can see, this see this can get very expensive. Mistakes can be devastating! A good shortcut would be to visit some equipment showrooms, write down model numbers of the components they use, take pictures, steal ideas. All of these components can be found used or discounted online. A hydraulic shop can help engineer this, but would not be fair to use their knowledge and not buy from them, (my opinion).
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Lifetime of Farm Machinery - by Joe Michaels. I am a mechanical engineer by profession, specializing in powerplant work. I worked as a machinist and engine erector, with time spent overseas. I have always had a love for machinery, and an appreciation for farming and farm machinery. I was born and raised in Brooklyn, New York. Not a place one would associate with farms or farm machinery. I credit my parents for instilling a lot of good values, a respect for learning, a knowledge of various skills and a little knowledge of farming in me, amo
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.