Posted by Dan in North Houston on May 07, 2018 at 08:22:30 from (216.136.87.146):
Posted last month on suggestions on how to get the end link out. I had already soaked it in penetrating oil in trying to get the lock pin out, but that did nothing for freeing up the end link. I had some brush to burn, so I put it in the hot coals for a few hours, then using some big shackles, hooked it up to a tree stump. I used compressed air to blow out anything that was inside, but no luck getting any movement. I baked it again overnight in hot coals, used compressed air, then hooked it to a large oak tree that I had cut down earlier. Probably 3000 pounds, drug it back and forth, no luck. I tried the sledge hammer trick, no luck. I baked it overnight again in hot coals, tried the tree drag and sledgehammer again, no luck. Using the shackle, I hooked it to the front end loader bucket, holding it up in the air suspended by the chain. I took a ladder to get in the bucket, then picked up the chain and let it drop - essentially make it into its own slide hammer. No luck. I was about to give up and mounted it back on the tractor. When I tried to put the lock pin back in, it wouldn't go. Although it didn't look like it, it had moved just enough that the lock pin would not seat. I tried the front end loader drop trick again, and after about 5 minutes, it finally came apart. The dirt and rust had fused together on the sides to add at least 1/8" of crud on each side. The crud was so hard that a wire wheel wouldn't dislodge it, I had to use a grinder to clean it up.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Lifetime of Farm Machinery - by Joe Michaels. I am a mechanical engineer by profession, specializing in powerplant work. I worked as a machinist and engine erector, with time spent overseas. I have always had a love for machinery, and an appreciation for farming and farm machinery. I was born and raised in Brooklyn, New York. Not a place one would associate with farms or farm machinery. I credit my parents for instilling a lot of good values, a respect for learning, a knowledge of various skills and a little knowledge of farming in me, amo
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.