Posted by d9gdon on May 16, 2018 at 21:02:16 from (159.203.61.231):
In Reply to: OT Electric gate posted by Elmo on May 16, 2018 at 20:34:46:
Quoting Removed, click Modern View to see
I've had my Apollo gate opener on my entry gate for 8 years now. My entry gate is a 16 ft steel pipe framed gate with hog panel welded on it at the bottom and then two horizontal pipes above the panel. The pipe frame and cross pipe is two inch. It is a heavy gate.
Here's a YouTube video. Mine has linkage welded onto the gate that gives it more leverage. I can't explain it other than it's like an elbow or a scissor link.
https://www.youtube.com/watch?v=Mkt708IlGmY
Here's a better example:
https://www.youtube.com/watch?v=JUBMxrm7kkc
Mine works great. It got struck by lightning about 5 years ago but Apollo warrantied it fully and replaced the board in it.
I'm on my second battery in all those years. It has a solar battery charger to keep the battery full.
I'm out of state now, but I could get you a picture of my gate in the next couple of weeks if you decide to go with this.
I'm really impressed with their durability since there's 4 of us that used it daily for the first 3 or 4 years, with 2 of them being teenagers going in and out more than 5 times a day.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.