Posted by Case Nutty 1660 on May 20, 2018 at 07:28:55 from (162.252.128.241):
In Reply to: Question for YT DOT posted by John in La on May 20, 2018 at 06:41:55:
No comment on your questions but I will add what I have learned by hauling heavy loads for the last 40 plus years,, from backhoes to D8N crawlers,, the way you have the chains running away from the tractor will always lets them work loose, if you try that hauling a backhoe or crawler ect it will move on the trailer in most any direction, if you hook straight across it will be as tight and in the same place when you get where you are going, be that 5 miles or 5000,, many do just as you show,, I see it all too often, if I can I always go right to the trailer frame and not the edges alone, depending on the quality of the trailer going to a stake pocket alone can just "bow" the trailer bed and you still do not have it tied tightly to the trailer, this is from my own experience's hauling in some of the most difficult places one has to haul too, take or leave my advice I only care if the item you are hauling stays on and gets to where you are going safely I have seen stuff being hauled that made me cringe
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
