Posted by NY 986 on May 22, 2018 at 12:46:15 from (184.53.48.77):
In Reply to: More 2+2 questions posted by Al Baker(pumpman) on May 22, 2018 at 10:44:45:
They were popular in pockets around NY when they sold new back in the late 1970's. There were several wet falls back to back around that time so guys who could afford them bought them to chop corn as they could get through the field. What hurt 2 + 2 sales were the late 1970's was when Deutz and Same were making their push for the same small dairy customer and farmers were suffering price shock on new US built units. To go along with that the 2 + 2 tractors carried a rather high selling price versus the competition. We bought a 4 wheel drive tractor in 1979 and we could price an 8440 Deere cheaper about any place than we could a 3788. What ultimately happened for us is we found a very low houred 8430 which we have to this day. The 1970's grain boom brought about increased trade in's on the local market that included tractors such as the Case 2470 so farmers not wanting to spend on new had alternatives. Less than a couple years after the 2 + 2 came out the grain boom ended and Farm Credit started tightening down on loans including for a lot of dairy's. For 1983 John Deere came out with its 50 series row crops which included MFWD and JD credit was a little easier to get at the time so JD gained a lot of market that might have gone to IH. Also, at that time IH was starting to circle the drain with no savior obvious to the farm community so that made customers skittish as to buying IH products.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
