Bryce, those spit -rim- wheels like you have are called widow makers, and good tire shops no longer work on them, insurance co will not cover work on them. They come apart like unscrewing an Oreo cookie in the middle. You can't see if they are put together right or not.
Split -ring- wheels with the ring(s) on the edge of the rim are perfectly fine and safe today.
Others have mentioned good metric size tubeless rims that will bolt right up, need different tires of course.
To stay with the 9-20 you have, there are many many military rims out there with the same bolt batter, and are a split ring. In like new shape.
The trouble is folks sell them for the tires, and never mention the bolt pattern or might even scrap the rim for iron when selling the tires off.
So you have to do a little scouting.
I know, that isw hat I went trough several years ago.
Anyhow, you have several good options available.
I would not mess with those widow maker style rims. They are scrap iron.. When I knew what I had and was looking for rims, two different shops mentioned issues they had years ago with them; on talked about cracked rafter in the roof where one hit, another place talked about someone badly hurt in another shop they knew of, and the one that bounced off the wall at their shop....
Only the bottom left is the bad type, all the others are good designs.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
