Posted by Texasmark1 on June 10, 2018 at 16:54:59 from (184.20.226.158):
In Reply to: JD 375 round baler posted by lee little on June 10, 2018 at 16:00:15:
My current baler is such. Tx Jim put me onto the problems.
First of all if you have a navel on one side, start the bale with fast back and forth movements of the baler over the WW. Say first 50' of ww when starting the bale. The navel is the result of loading one side of the bale chamber initially.
Second is you are not feeding hay to the edges of the bale chamber. The sensors are on the outside belts. So, if you want them to register hay, there needs to be some at the edges. Practice around here was to zig zag across the WW as you bale, not as fast as initially, but back and forth keeping your eye on the black bars.
When low fill, when high go to the other side, when even, bale should be symmetrical.
On this 5' baler a smaller WW works better, unlike the 4' where you can get by having a fat ww without any zig zagging. Reason for the smaller ww is that you can move over to the side, like my tractor is setup with 6' max width on 16.9x28 rears meaning that if I want to fill the sides of a 5' bale chamber, the wheel will be right on top of the WW.
If you get into irregular terrain, or get into huge globs of hay, like in an irregular field where raking at the ends of the rows produces a big pile, stop for a minute and let the baler digest the wad and see where you markers are....then proceed as they indicate.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Good As New - by Bill Goodwin. In the summer of 1995, my father, Russ Goodwin, and I acquired the 1945 Farmall B that my grandfather used as an overseer on a farm in Waynesboro, Georgia. After my grandfather’s death in 1955, J.P. Rollins, son of the landowner, used the tractor. In the winter 1985, while in his possession the engine block cracked and was unrepairable. He had told my father
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
