Posted by Texasmark1 on June 15, 2018 at 16:56:45 from (184.63.24.146):
In Reply to: Hay and 90 degrees posted by Steve in wi on June 15, 2018 at 10:33:03:
I cut Tuesday, early in the morning on fairly thick Sorghum-Sudan Haygrazer. Came back with 2 passes of a crimper and 3 passes with a tedder. Raked it this afternoon for baling tomorrow. Even though we have had mid 90's, mostly sunshine, few clouds on some days, temp well above dew point so non overnight condensation, the humidity has been high, over 50% most of the time and that doesn't help.
I use the 3 turn twist test for ready: Wad of hay grasped with both hands, fingers down around hay, hands butted together, twist like you are raising a scissor jack. If you make 3 complete turns and it pops during that time it will bale ok. If only one or two stems in the wad resist, that is ok too but best to leave the bales out to air out for awhile....a week or so. If you fail the test, question your moisture level.
I barely passed today, should be ok for tomorrow. One thing about my JD baler, it doesn't care how dry the hay gets, it eats it anyway. One thing good about Haygrazer, the leaves stay intact even when very dry. Wink!
For once in my life, the weather isn't threatening me and causing me to make irrational decisions on when to bale.
If you were baling bermuda grass you'd probably be ok. SS?????, especially if you have large stems, no crimper, might iffy. Never did Alfalfa so can't say.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Listening to Your Tractor - by Curtis Von Fange. Years ago there was a TV show about a talking car. Unless you are from another planet, physically or otherwise, I don’t think our internal combustion buddies will talk and tell us their problems. But, on the other hand, there is a secret language that our mechanical companions readily do speak. It is an interesting form of communication that involves all the senses of the listener. In this series we are going to investigate and learn the basic rudimentary skills of understanding this lingo.
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.