Posted by LOU from Wis. on June 15, 2018 at 20:12:40 from (184.158.11.60):
In Reply to: Re: 706 brakes posted by LOU from Wis. on June 15, 2018 at 10:35:16:
That should been orings not brings. We used a 2 gallon plastic clearishing lawnmower fuel tank and drilled a hole in the top of the fuel cap and added a tire valve stem,then attached a clear hose on the fuel nipple at the bottom of the fuel tank and put about a gallon of hi Tran fluid in the gas tank. Cut the regulated air pressure back to 20 lbs and ratchet strapped the tank to the tire above the height of the bleeder screw. Attached the clear hose to one side of the bleeder screw and opened it up while the tractor was running. Pumped the brake pedal until pressure was back and closed off the bleeder screw. Done the same to the other side,and have brakes a full pedal. Don't know if I explained it well enough the first time so hopefully I did this time. Thanks to all who answered and helped. According to the mechanic who we got the help from, he has run into more than a few that has had this happen to. A air lock that won't be bled out of and his way worked for us. So maybe someone else can get some use out of this knowledge if they run into the same problem. Regards, Lou & Victor.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
