My wood deck is now 23 years old and going strong. All treated wood with 5/4 deck planks and joists at 16" centers. Wood is a moving product. It gets pressure washed every year, and stained with a transparent stain & water proofing every 3 years. Prior to staining, I go over areas like hand rails and such with a quick standing of a random orbital sander and 80 grit paper to get rid of the raised grain. Deck is about 50% shaded thru the day.
Composite decking is more maintenance resistant, and more costly. Spacing is critical, as it expands in the heat and can buckle if not installed correctly. Can also be really hot on bare feet if in direct sun. Still needs to be pressure washed on occasion. Any deck I have seen of this stuff still weathers some over time.
Decks with treated wood need to still be designed to shed water. Have seen some bad workmanship out there. Wood ages and gets weather checked over time. That's the nature of the stuff. Some folks say a deck needs to be replaced at this point. Your choice. Rotted? Yes, replacement is needed. Cause for that can be poorly treated wood, or poor design in wet areas. Wood treated for ground contact normally has a higher level of treatment in it, but folks don't look for that stuff when they buy their materials.
If you think you can build a deck to live out in the weather, and look like a fine hardwood floor in your house for years to come, expect to be disappointed.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: 1964 JD 2010 Dsl - Part 2 - by Jim Nielsen. Despite having to disassemble the majority of my John Deere 2010's diesel engine, I was still hopeful I could leave the engine-complete with crankshaft and camshaft-in the tractor. This would make the whole engine rebuild job much easier-and much less expensive! I soon found however, that the #4 conrod bearing had disintegrated, taking with it chunks of the crankshaft journal. As a resul
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
