Posted by unc on July 12, 2018 at 21:44:32 from (69.168.165.219):
In Reply to: Buying a Hobby Farm posted by StrikeForce on July 12, 2018 at 20:49:25:
We had a bit of good fortune, and were able to buy five acres across the valley. Its a little hillier than I like, but is on a good, hard surfaced road, and overlooks the valley. A couple of flat spots for a house and shop, and a 7 1/2 GPM well. There's really not enough land to do anything more than exercise my tractors, but there are some small pieces of land up the road that could be rented. All in all, it's limited as far as farming goes, but it's a great spot to set up a machine shop and do the work I want to do, rather than what I have to do. If you can make it happen, bite the bullet, take the plunge, and go for it. You're probably not the only guy in your area looking for a nice spot.
We looked at a lot of places around the district, but distance to town and road conditions are factors. This place is thirteen minutes on pavement to the grocery store, and is the first road ploughed in the winter. I don't think we'll get hurt down the road, as property values in this area have shown a modest but steady increase over the years. Best of luck, unc
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Usin Your Implements: Bucket Loader - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.