Posted by Bullet23 on July 16, 2018 at 19:28:19 from (107.202.35.201):
Hi guys, I need some help trying to figure out how to press on a new center support bearing on to the front driveshaft of a 1977 International Loadstar 1754 with the DT466 and the Spicer CM5252A Transmission.
The other day we were out delivering a load of gravel and on the way back the rubber boot surrounding the center support bearing gave way and the driveshaft was banging around in the metal U shaped bracket for about 10 miles. I ended up taking the driveshaft to a local 4x4 shop and they said that someone had welded the splines onto the driveshaft and they couldn't press the bearing onto the shaft. When I look at the spline section it appears to be pressed into me and does not appear welded. If anyone has done this type of repair and can direct me with the right steps that would be great.
I have posted pictures of the dump truck along with the drive shaft and the new center support bearing. In the pictures of the driveshaft the section that still has u joints attached the back of the large driveline drum brake assembly on the back of the transmission. The splines connect to the slip joint which connects back to the large second piece of the drive shaft.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
